Setting The Pen Speed Mode - GRAPHTEC MP303-04 User Manual

2.5 Setting the Pen Speed Mode

The pen speed mode can be set to Manual or Program mode.
Program mode: Command input specifying the pen speed will override the pen speed setting that was manually
selected at the plotter's control panel.
Manual mode : The pen speed setting that was manually selected at the control panel remains effective and
command input specifying the pen speed will be ignored.
I Procedure
(1) Press the
MOD E
(2) Press the
E N T E R
displayed).
(3) Press the or
currently set to M (Manual).
(4) Press the or
speed mode setting blinks).
Speed M : Selects "Manual" pen speed mode.
Speed P : Selects "Program" pen speed mode.
(5) When the desired status is displayed, press the
(6) If the setting is correct, press the
to take effect.
To cancel the setting and return to Step (1), press the
key and then press the
key to display the command selection menu (the currently selected command mode is
（command mode）
key until the "Speed" menu is displayed. In this example, the pen speed mode is
Speed M
key to switch the pen speed mode between M and P (the bit which affects the pen
Speed P
ENTorCAN
E N T E R
Ready Ready
or key to display the message below.
Setup
DipSW.
key. The prompt below appears.
E N T E R
Reset?
key. Pressing the key resets the plotter to allow your new setting
C AN C EL
X=
or
Y=
2-7
key.