5.1
Outline of Manual Position Adjust
For axis adjustment, the inclination of the axis can be adjusted based on the coordination of 2 grit and/or
registrations marks. Furthermore, it's possible to adjust the distance by entering the distance of each point.
Move the tip of each tool to the appropriate point.
Use media that has the plots (grits or alignment marks) required to find the X-Y axis and the origin.
Alignment registration mark
There are two alignment marks. The position of each alignment mark is shown in the next figure.
2POINTS
Example of axis adjustment
The pre and post adjustment grid appears as follows
Adjustment
point 2
Cutting
standards
Reference of this unit
There is a deviation between the X-Y axis and origin point
of the unit and the media plotted.
Second point
First point or origin point
Media already cut and set again
Adjusting the
coordinate axes
Adjustment point 1
(Origin point of the media already cut)
Origin point
To eliminate the deviation, correct the deviations of the
X-Y axis and origin point.
5-2
New origin point