Setting The Dip Switch; Mounting The Switch - Comtrol ROCKETLINX ES8108 Quick Installation Manual

Wiring the Alarm Relay Output
The alarm relay output contacts are in the middle of the terminal block connector. By inserting
the wires and setting the DIP switch of the respective Port Alarm to "ON", the alarm relay
output detects any port failures and forms a short circuit. The alarm relay output is "Normal
Open." The alarm relay output closes if there is a port or power failure.

Setting the DIP Switch

Switch Status
On
1 to 8
(Port)
Off
On
9
(Power)
Off

Mounting the Switch

Mount the ES8108/ES8108F on the DIN rail using the DIN rail clip that is attached to the rear
of the unit.
Maximum 0.5A/24VDC
Alm
PW1 PW2
Alarm Control
port 1~8
Description
Enables the port link down alarm for the corresponding port.
Disables the port link down alarm for the corresponding port.
Enables the power failure alarm.
Disables the power failure alarm.
Alarm
System
Extra Power
System
power
3