Configuration Using the Command Line Interface
(CLI)
Overview
The ES8508 provides in-band and out-band configuration methods:
•
Out-band management means that you configure the ES8508 using the RS-232 console cable and the
Command Line Interface (CLI) to access the ES8508 without attaching an admin PC to the network. You
can use out-band management if you lose the network connection to the ES8508.
•
In-band management means that you connect remotely using the ES8508 IP address through the
network. You can remotely connect with the ES8508 embedded Java applet web user interface or a Telnet
console and the CLI.
If you are planning on using in-band management, you need to program the ES8508 IP address to meet your
network requirements. The easiest way to configure the IP address is using a Windows system and PortVision
DX, which is discussed in
If you want to use the web user interface for configuration, see
Page 35.
Use the following procedures to access the ES8508 using the CLI:
•
Using the Serial Console
•
Using a Telnet/SSH Console
This section contains information about the following groups of commands:
•
Basic Settings (CLI)
•
Port Configuration (CLI)
•
Network Redundancy (CLI)
•
VLAN (CLI)
on Page 164
•
Private VLAN (CLI)
•
Traffic Prioritization (CLI)
•
Multicast Filtering (CLI)
•
SNMP (CLI)
on Page 177
•
Security (CLI)
on Page 178
•
Warnings (CLI)
on Page 180
•
Monitor and Diag (CLI)
•
Saving to Flash (CLI)
•
Logging Out (CLI)
•
Service (CLI)
on Page 186
RocketLinx ES8508 Series User Guide: 2000575 Rev. A
Configuring the Network Settings
on Page 146
on Page 152
on Page 155
on Page 167
on Page 171
on Page 174
on Page 183
on Page 186
on Page 186
on Page 21.
Configuration Using the Web User Interface
Configuration Using the Command Line Interface (CLI) - 131
on