Using The Command Line Interface (Cli); Using The Serial Console - Comtrol RocketLinx ES7528 User Manual

Using the Command Line Interface (CLI)

Use the following procedures to access the RocketLinx ES7528 using the CLI:
•

Using the Serial Console

•
Using a Telnet Console
Using the Serial Console
Comtrol provides one RS-232 DB9 console cable with the RocketLinx ES7528.
1. Attach one end of the RS-232 DB9 connector to your PC COM port and connect the other end to the Console port of the
RocketLinx ES7528. If you misplace the cable, you can use this console cable pin assignment or purchase a null-modem
cable.
2. Start a terminal program such as HyperTerminal or the Comtrol Test Terminal program. You can download Test Terminal
from the or locate it on the CD shipped with the RocketLinx ES7528.
ftp site
• HyperTerminal
- Go to Start -> Program -> Accessories -> Communications -> HyperTerminal
- Enter a name for the new console connection and click OK.
- Select the appropriate COM port number.
- Set the serial settings.
- Press he Enter key in the Terminal window, t
• Test Terminal (WCom2)
- Unzip Test Terminal and execute Wcom2.exe.
- Select Open Port and click the appropriate COM name.
- Click Settings, use the table (above), and then click Ok.
- Press he Enter key in the Terminal window, t
After it is connected, you can see the Switch login request.
Using the Command Line Interface (CLI)
Serial Settings
Baud Rate 9600
Data bits 8
Parity None
Stop Bit 1
Flow Control None
RocketLinx ES7528 Industrial Managed PoE Rack Mount User Guide: 2000509 Rev. A - 19
Value
Preparation for Management