Redboot Command Overview - Comtrol DeviceMaster DM-2000 Series Installation And Configuration Manual

RedBoot Command Overview

The following table is an overview of RedBoot commands available. After accessing RedBoot, you can review
the list of commands online by entering help and pressing the Enter key.
For more detailed information, see the eCos Reference Manual that you can download from:
downloads.comtrol.com/dev_mstr/rts/software/redboot/user_guide.
auth
{noaccess, none, basic, md5, invalid}
boardrev†
cache [ON | OFF]
channel [-1|<channel number>]
chassis
cksum -b <location> -l <length>
clearconfig
disable
fis {cmds}
flash
go [-w <timeout>] [-c] [-n] [entry]
help <topic>
history
ip [addr mask gateway]
load [-r] [-v] [-h <host>] 
[-p <TCP port>]
[-m <varies>] 
[-c <channel_number>]
[-b <base_address>]
<file_name>
loop 232|422|int port-number
mac†
model†
password {password}
ping [-v] [-n <count>] 
[-l <length>] [-t <timeout>] 
[-r <rate>]
[-i <IP_addr>] -h <IP_addr>
reset
secureconf [disable|enable]
securedata [disable|enable]
DeviceMaster Installation and Configuration Guide: 2000594 Rev. F
RedBoot Commands
Sets or displays web authentication. The default is set to none, which
means that there is no authentication required to access the web server.
To deny access to the web server, click noaccess or invalid. If access is
attempted, a message appears to notify the user that access is denied.
To configure the web server to request an un-encrypted password, click
basic. To configure the web server to request an encrypted password, click
md5. (Some browsers do not support the md5 command.)
Displays the board revision.
Manages machine caches.
Displays or switches the console channel.
Displays chassis information.
Computes a 32-bit checksum [POSIX algorithm] for a range of memory.
Clears the application configuration.
Disables automatic load of the default application.
Manages flash images. See Chapter 2 of the
{cmds} information.
Shows flash information.
Executes code at a location.
Displays available RedBoot commands.
Displays command history.
Displays or sets the IP address configuration.
Loads a file from TFTP server or XModem.
Runs loopback test on port. The DeviceMaster Serial Hub does not
support this command.
Displays Ethernet MAC address.
Shows model number.
Sets or deletes the password.
Network connectivity test.
Resets the DeviceMaster.
Sets or displays secure config enable.
Sets or displays secure data enable.
RedBoot Procedures
http://
eCos Reference Manual
RedBoot Procedures - 137
for