Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 663

Supporting procedures
Replacing System Components
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Gently tighten fan unit screws.
7
E
N D O F
...................................................................................................................................................................................................
Provisioning an SFD40/SFD40B in a FOADM node
Procedure
Before you begin
Note: Ensure that no optical channel service has been provisioned before the
SFD40/SFD40B has initialized. If optical channel services are present, delete them
(see
Note: Before the SFD40/SFD40B is in service, the OTUs connected to the
SFD40/SFD40B should be turned off to avoid channel leakage.
...................................................................................................................................................................................................
Properly connect the power cables of the SFD40/SFD40B card.
1
...................................................................................................................................................................................................
Connect the SFD40/SFD40B card to the amplifier cards with the inventory cable.
2
...................................................................................................................................................................................................
3 Optional: To monitor the SFD40/SFD40B temperature alarms and Input LOS alarm from
the NE management software, connect the SFD40/SD40B card to the User Panel with the
housekeeping cable and IDC block.
...................................................................................................................................................................................................
4 Power up the SFD40/SFD40B card, and wait for it to initialize (about 5 to 10 minutes).
Note the SFD40/SFD40B status by monitoring the temperature LED of the
SFD40/SFD40B. The SFD40/SFD40B should in service when the temperature and
initialization LEDs turn green. Also check the alarm status on the NE management
software to ensure that the housekeeping cable has been properly connected.
...................................................................................................................................................................................................
5 Provision the optical channel service using the NE management software, and set up the
link.
E
N D O F
...................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
S T E P S
Step 3).
S T E P S
Replacing the Fan
3-55