Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 561

Trouble-clearing procedures
SWUPGCOMMIT
....................................................................................................................................................................................................................................
Corrective Action
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
To upgrade to a new release or clear the alarm, the current software load must be
1
committed. Enter the following command to commit the software:
CLI
E
N D O F
...................................................................................................................................................................................................
SWUPGFAIL
SWUPGFAIL (Software Upgrade Failed)
The SWUPGFAIL alarm is applicable at the NE-level and/or the card-level. This alarm is
raised when the NE or card fails to upgrade to the designated load.
Severity
Service affecting?
Applicability
Corrective Action
A cold reset, reseat, or replacement of a card is service impacting if the card is currently
carrying services. To determine if any services are currently carried over a card, perform
the procedure
If there are services currently carried over the card, it may be best to wait for a
maintenance window before resetting, replacing, or reseating the card.
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
config software upgrade commit
S T E P S
Minor
No
•
•
NOTICE
Service-disruption hazard
"Reseating a Card" (p.
SWUPGCOMMIT (No committed software load (Autoinstall
NE level: SYSTEM
Card level: 11STAR1, 11STMM10, 11STGE12, ALPHG,
AHPHG, CWR, OPS, SVAC
3-19).
disabled))
2-311