Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 362

Trouble-clearing procedures
HLDOVRSYNC
....................................................................................................................................................................................................................................
HLDOVRSYNC
HLDOVRSYNC (System timing is in autonomous holdover
synchronization mode)
The OT port has detected a HLDOVRSYNC at the SYNC layer. A SYNC detects
HLDOVRSYNC when system timing is in autonomous holdover synchronization mode.
Severity
Service affecting?
Applicability
Corrective Action
...................................................................................................................................................................................................
1 Check all references.
CLI
WEBUI
E
N D O F
...................................................................................................................................................................................................
HWNOTSUPPORTED
HWNOTSUPPORTED (Hardware not supported for current
configuration)
The HWNOTSUPPORTED condition is raised during insertion of an Equipment
Controller in slots 1 or 18, when R1.0.5 software active is detected on the 1830 PSS-32.
Severity
Service affecting?
Applicability
....................................................................................................................................................................................................................................
2-112
Not alarmed
No
SYNC
show card 11dpe12e shelf/slot synce lineref {1-4}
Select the 11DPE12E card in the Equipment Tree.
Select LINEREF {1-4}.
S T E P S
Major
Yes
ECb
HLDOVRSYNC (System timing is in autonomous holdover
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
synchronization mode)
Issue 1 June 2011