Supporting procedures
Replacing System Components
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Select
8
Result:
...................................................................................................................................................................................................
9
Select the
...................................................................................................................................................................................................
Click
10
Apply
...................................................................................................................................................................................................
Restore the database (see
11
...................................................................................................................................................................................................
Replace the User Panel and make all connections as described in the Alcatel-Lucent 1830
12
Photonic Service Switch Release 36/32/16 (PSS-36/PSS-32/PSS-16) 3.6.0 Installation and
System Turn-up Guide.
...................................................................................................................................................................................................
13
Backup the database again, now that the User Panel is successfully replaced.
E
N D
O F
...................................................................................................................................................................................................
Replacing the User Panel Using CLI
...................................................................................................................................................................................................
1
Save the TID, User Panel OADM port details, loopback IP address, and static routing and
gateway information, or know where to retrieve this information to use if a reboot
interrupts this procedure.
...................................................................................................................................................................................................
2
Type the following CLI commands, pressing
1.
show general name
2.
show interface loopback
3.
show interface usrpnl oamp
4.
show general name
Note the IP address and administrative state.
5.
show cn routes static
...................................................................................................................................................................................................
Check whether any alarms are present by typing
3
Then backup the current database to use if a reboot interrupts the procedure.
....................................................................................................................................................................................................................................
3-36
Administration
>
Database
The USRPNL Replacement Update window is displayed.
Synchronize USRPNL with NE database
>
.
Close
"Restoring a Database" (p.
S T E P S
>
User Panel Replacement Update
field.
3-14)).
Enter
after each command:
. Clear any present database alarms.
alm
Replacing the User Panel
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011