Trouble-clearing procedures
WKSWBK
....................................................................................................................................................................................................................................
Corrective Action
At the end of each step wait to see if the fault clears. If not, continue with the next step.If
there are no faults against working facility/equipment:
...................................................................................................................................................................................................
Wait for the wait-to-restore timer to expire.
1
...................................................................................................................................................................................................
2
Determine which side is the working side and which side is the protection side.
CLI
...................................................................................................................................................................................................
Display the protection group for the associated shelf/slot/port.
3
CLI
WEBUI
...................................................................................................................................................................................................
Check the administrative state on the protection side client/line ports.
4
CLI
WEBUI
If the state is down, the switch may have been caused by user administrative provisioning.
...................................................................................................................................................................................................
Check for faults on the protection side card, or the protection side client/line ports.
5
CLI
...................................................................................................................................................................................................
6
If...
faults are present,
....................................................................................................................................................................................................................................
2-354
show aps
group
config aps group
Select the port of the card, and click the Port tab.
show interface
From the Equipment Tree, select the card, and select the desired port.
alm
WKSWBK (Automatic switch to working)
detail
Then...
proceed to the appropriate procedure for
clearing the faults.
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011