Supporting procedures
Replacing System Components
....................................................................................................................................................................................................................................
Replacing an XFP Module
...................................................................................................................................................................................................
Deprovision the client port.
1
CLI
WEBUI
...................................................................................................................................................................................................
Ensure that all of the fibers connected to the XFP module are labeled.
2
...................................................................................................................................................................................................
3
Remove and cap all of the fibers connected to the SFP module.
...................................................................................................................................................................................................
Use the hook on the end of the XFP extractor/LC connector tool (or similar tool) to pull
4
down the bail on the XFP.
Figure 3-3 XFP bail
....................................................................................................................................................................................................................................
3-30
config port card type shelf slot state down
config port card type shelf slot delete
In the Equipment Tree, select the client port.
In the Primary State field, select
Click the Delete tab.
Select Delete this Port, and click
Replacing an XFP Module
.
Out of Service
Submit
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011