Supporting procedures
Rebooting Components
....................................................................................................................................................................................................................................
WEBUI
...................................................................................................................................................................................................
2
Perform a cold restart of the entire NE, instead of each individual card.
CLI
WEBUI
E
N D
O F
...................................................................................................................................................................................................
Reseating a Card
Procedure
A card reseat is service impacting if the card is currently carrying services. To discover if
any services are currently carried over a card, perform the procedure
Services on a Port" (p.
be best to wait for a maintenance window before reseating the card.
...................................................................................................................................................................................................
1
Ensure that all of the fibers connected to the card are labeled.
...................................................................................................................................................................................................
Remove and cap all of the fibers connected to the card.
2
...................................................................................................................................................................................................
3
Unlock the card latch. Place a thumb or finger on the latch release/locking pin located
behind the latch cover and open the latch by lifting up and out. This will partially unseat
the card from the backplane.
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
Select a card or port on the Equipment Tree.
Set the Primary State field to
config admin force resetne
reset cold
Select the System on the Equipment Tree for the NE.
Click the
Reboot
Select
Cold Reboot
S T E P S
NOTICE
Service-disruption hazard
3-10). If there are services currently carried over the card, it may
Maintenance
tab.
>
Submit
.
Cold Restart of a Pack with Traffic
.
"Checking for
3-19