Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 562

Trouble-clearing procedures
SWUPGFAIL
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Determine the reason why the NE or card failed to upgrade.
1
CLI
...................................................................................................................................................................................................
2 Based on the information provided by the status, as listed in the following table,
determine the cause of the failure and resolve that issue first.
Table 2-2
Upgrade
status
Transfer failed
File access
failed
File corruption
detected during
transfer
Timeout
Operation in
progress
Install in
progress
Transfer in
progress
Card not found
Card type not
found in catalog
....................................................................................................................................................................................................................................
2-312
config software upgrade status
Software upgrade status and actions
Action
This is an internal error indicating a failure between the EC and another
card. Retry the upgrade process.
Problem accessing the load file on the EC disk. Retry the upgrade process.
Retry the upgrade process.
The upgrade timed out. Retry the upgrade process.
No action required.
No action required.
Attempted to do an upgrade while SWL was busy.
1. Wait for the action to complete, or abort the current action (config
software abort).
2. Retry the upgrade process.
A card was removed while an upgrade was in progress. Retry again (with or
without the missing card).
The software release does not contain a software load for the card.
1. Check that you are upgrading to the correct software load. Retry with
the correct load.
2. If you are upgrading to the correct load, determine if the card in question
is required for normal operations.
3. If the card is not required, remove the card from the system.
4. If the card is required for normal operation, contact your service
representative.
SWUPGFAIL (Software Upgrade Failed)
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011