Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 656

Supporting procedures
Replacing System Components
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Set up the software server information. Type each command line, and press Enter:
9
1.
config software server ip
2.
config software server userid
Enter your password when prompted.
3.
config software server root
4.
config software server detail
...................................................................................................................................................................................................
Set up the database server information. Type each command line, and press Enter:
10
1. Type
2.
config database server ip
database is stored.
3.
config database userid
4.
config database path
saved.
5.
config database detail
...................................................................................................................................................................................................
Upgrade the software. Type each command line, and press Enter:
11
1.
config software upgrade manual audit
no backup enforced
Software server root parameter value to make the path on the Remote File Server
where the software release resides. See also the Alcatel-Lucent 1830 Photonic Service
Switch Release 36/32/16 (PSS-36/PSS-32/PSS-16) 3.6.0 Installation and System
Turn-up Guide.)
2.
config software upgrade manual load
3. Type
The system will reboot.
...................................................................................................................................................................................................
12 Login to the NE.
Type
config software upgrade commit
...................................................................................................................................................................................................
Telnet to the NE where the Equipment Controller is located.
13
...................................................................................................................................................................................................
Replace the Equipment Controller in the shelf. Wait a few minutes for the Equipment
14
Controller to initialize.
....................................................................................................................................................................................................................................
3-48
database server config
. (The release directory would be combined with the
config software upgrade manual activate
Replacing an Equipment Controller in a Nonredundant Shelf
IP address
user ID
/path
.
IP Address, using the IP address where the
, then enter your user ID and password when prompted.
directory with the path on the PC where the database is
to verify your IP address, user ID, and path.
.
release directory on RFS
.
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011