Trouble-clearing procedures
UNKNOWNMOD
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Perform a cold reset of the card on the card where the pluggable module defect is raised.
5
CLI
WEBUI
...................................................................................................................................................................................................
Reseat the card. Refer to
6
...................................................................................................................................................................................................
. If there is no transmission, check that the provisioned signal rate is supported by the
7
pluggable module that is present. If not, use a different pluggable module, or change the
signal rate provisioning to a value supported by the pluggable module.
...................................................................................................................................................................................................
8
Replace the card. Refer to
E
N D
O F
...................................................................................................................................................................................................
UPM
UPM (GFP User Payload Mismatch)
The OT has detected a GFP User Payload Mismatch.This condition is raised when the
encapsulation mode provisioning for the two OTs on opposite ends of an optical link do
not match
Severity
Service affecting?
Applicability
....................................................................................................................................................................................................................................
2-336
config card
Select the card, click the
"Reseating a Card" (p.
"Replacing System Components" (p.
S T E P S
Critical
Yes
112SCX10, 112SX10L, 11QPA4, 11STAR1, 11STMM10,
43SCX4, 4DPA4
UNKNOWNMOD (Pluggable Module Unknown)
card_type shelf slot
reset cold
tab, select
Reboot
3-19).
>
.
Cold Reboot
Submit
3-20).
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011