Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 454

Trouble-clearing procedures
NET
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Reseat the card where the NET condition is present
13
...................................................................................................................................................................................................
14 Replace the card that is the source of the Ethernet signal.
...................................................................................................................................................................................................
Replace the card where the NET condition is present
15
E
N D O F
...................................................................................................................................................................................................
Corrective Action
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
Check that the source is operational up.
1
...................................................................................................................................................................................................
2 Check that the cable/fibre is plugged in correctly.
...................................................................................................................................................................................................
Check that the other end is plugged into a matching ethernet source (if this is an ALPHG
3
port, the matching source is another ALPHG port).
...................................................................................................................................................................................................
4 Check that cable/fibre is the correct type for the Ethernet port.
...................................................................................................................................................................................................
If a cable/fibre tester is available check that the cable/fibre is correct, otherwise try
5
another cable/fibre.
...................................................................................................................................................................................................
6 Perform a cold reset of the card.
CLI
WEBUI
Note: Refer to Caution at the beginning of this procedure.
...................................................................................................................................................................................................
7 Refer to
....................................................................................................................................................................................................................................
2-204
S T E P S
config card
Select the card, click the
"Reseating a Card" (p.
card_type shelf slot
reset cold
Reboot tab, select
3-19).
NET (Link Down; Data Link Down)
Cold Reboot > Submit .
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011