Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 388

Trouble-clearing procedures
LOF
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Remove the fiber from the receive port where the LOF is raised and measure the optical
5
power.
If...
the optical power is below the required
threshold,
the optical power is within the required limits,
If the LOF condition is still present, the problem may be with the card.
...................................................................................................................................................................................................
6 Perform a warm reset of the card exhibiting the Loss of Frame.
CLI
WEBUI
...................................................................................................................................................................................................
If the client port has an pluggable module installed, verify the pluggable module (this
7
includes checking the pluggable module and replacing if necessary; do this before cold
reset or reseat as it does not affect other client signals).
...................................................................................................................................................................................................
Perform a cold reset of the card exhibiting the Loss of Frame.
8
Note: Refer to Caution at the beginning of this procedure.
CLI
WEBUI
...................................................................................................................................................................................................
Reseat the card. Refer to
9
...................................................................................................................................................................................................
10 Replace the card. Refer to
and repair process in the Customer and Product Support guide to return the faulty card to
an authorized repair center for replacement.
E
N D O F
...................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-138
config card
Select the card, click the
config card
Select the card, click the
"Reseating a Card" (p.
"Replacing System Components" (p.
S T E P S
Then...
using standard optical fiber jumper cleaning
procedure, clean the fiber, and measure the
power again.
clean the receive connector on the card.
card type shelf slot
reset warm
Reboot tab, select
card_type shelf slot
Reboot
3-19).
Transponder Client Port Loss of Frame
Warm Reboot > Submit
reset cold
tab, select Cold Reboot
3-20). Follow the return
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
.
> Submit .