Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 509

Trouble-clearing procedures
PWRADJFAIL
....................................................................................................................................................................................................................................
PWRADJFAIL (Power Adjustment Failure)
Corrective Action
A cold reset, reseat, or replacement of a card is service impacting if the card is currently
carrying services. To determine if any services are currently carried over a card, perform
the procedure
If there are services currently carried over the card, it may be best to wait for a
maintenance window before resetting, replacing, or reseating the card.
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1
If...
the system is equipped with the
SFD40/SFD40B,
the system is not equipped with the
SFD40/SFD40B,
...................................................................................................................................................................................................
On the FOADM terminal with SFD40/SFD40B packs (see
2
SFD40/SFD40B in a FOADM node" (p.
SFD40/SFD40B.
CLI
WEBUI
Note the SFD40/SFD40B status by monitoring the temperature LED of the
SFD40/SFD40B. The SFD40/SFD40B should in service when the temperature and
initialization LEDs turn green. Also check the alarm status on the NE management
software to ensure that the housekeeping cable has been properly connected.
...................................................................................................................................................................................................
If the SFD40/SFD40B has been initialized, and has a temperature alarm, delete all the
3
optical channel services and turn off OTU lasers connected to SFD40/SFD40B.
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
NOTICE
Service-disruption hazard
"Reseating a Card" (p.
alm
Select Reports
3-19).
Then...
continue with
proceed to
3-55)), check the alarm status of the
> Alarm List > Total .
PWRADJFAIL (Power Adjustment Failure)
Step 2.
Step 6.
"Provisioning an
2-259