Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 628

Supporting procedures
Reseating a Card
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Grasp the card by the open latch and slide the card out of the slot an additional 1 cm
4
(about 1/4 inch) being careful not to pull on any connected fibers on the NE. You will
encounter some resistance while the card is seated on the backplane. Use a gentle pulling
force to unseat the card from the backplane. All of the LEDs on the card will be off when
the card is fully unseated.
...................................................................................................................................................................................................
Wait for 10 seconds.
5
...................................................................................................................................................................................................
Grasp the card by the latch, with the latch in the open position.
6
...................................................................................................................................................................................................
Ensure that no fibers from adjacent cards are in the way, and slide the card into the slot.
7
You will encounter some resistance when the card contacts the backplane. Use gentle
force to fully seat the card on the backplane.
...................................................................................................................................................................................................
Lock the card into place by closing the latches. As the latches close, they push against the
8
latching tabs on the shelf or cross member, further seating the card. Continue to close the
latches until they are flush with the card faceplate, locking the card in place.
...................................................................................................................................................................................................
Once the port LEDs on the card have lit up, uncap, clean, and reconnect the fibers.
9
...................................................................................................................................................................................................
Check the card for alarms:
10
CLI
E
N D O F
...................................................................................................................................................................................................
Replacing System Components
Slot Equipage Requirement
Blanks are used to cover unused slots to improve cooling air flow. All slots in the shelf
must be occupied with circuit packs or blanks, and all packs must be fully inserted into
the shelf to maintain proper air flow. The shelf must not have an empty slot. Empty slots
or partially inserted cards will decrease air flow across installed circuit packs and will
....................................................................................................................................................................................................................................
3-20
alm
S T E P S
Procedure
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011