Installation - Automation Direct DURApulse GS4 User Manual

Appendix B: Optional I/O and Communication Cards
i
ntrODUCtiOn
GS4 drives have several option cards that can be used to expand the functionality of the drive.
Input/Output cards are available to provide additional DC I/O, 120VAC outputs, and relay outputs.
Communication interface cards are also available to provide ModbusTCP or EtherNet/IP™
communication. Only one additional I/O card can be installed in a GS4 drive at a time, and only
one comm card can be installed in a drive at a time.
o C
pTion ard
• Any optional comm card must be installed in Slot #1�
• Slot #2 is reserved for firmware upgrade module� See the GSoft2 helpfile for information on how
to upgrade drive, keypad, and comm card firmware�
• Any optional I/O card must be installed in Slot 3�
Part Number
GS4-06CDD
GS4-06NA
GS4-06TR
GS4-CM-MODTCP Modbus TCP comm card
GS4-CM-ENETIP
r C
eMOving the
WARNING: Ac
coNNect oR dIscoNNect WIRes oR coNNectoRs WhIle poWeR Is ApplIed to the cIRcuIt
must be peRfoRmed oNly by A quAlIfIed techNIcIAN
WARNING: A
the poWeR hAs beeN tuRNed off
"dIsplAy led"
uNtIl All
compoNeNts exposed WIthIN the
NOTE: To prevent damage during installation, remove the digital keypad and cover before option
card installation. See "Chapter 2: Installation and Wiring" for instructions.
Page B–2
l
oCaTions
GS4 Optional I/O Cards
Description
4-point DC input, 2-point DC output card
6-point AC input card
6-point relay output card
EtherNet/IP comm card
s C
arD lOt Over
INput poWeR must be dIscoNNected befoRe peRfoRmING ANy mAINteNANce
chARGe mAy stIll RemAIN IN the
. t
o AvoId peRsoNAl INjuRy
lIGhts oN the dIGItAl keypAd ARe off
Ac
dRIve
DuRA
Placement
Slot 3
Slot 3
Slot 3
Slot 1
Slot 1
.
dc-
lINk cApAcItoR WIth hAzARdous voltAGes
,
do Not Remove the coveR of the
. d
o Not touch these lIve pARts
GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
pulse
Slot 3
Slot 2 Slot 1
(factory-installed card)
. d
. m
AINteNANce
. p
leAse Note thAt theRe ARe lIve
.
o Not
,
eveN If
Ac
dRIve