Automation Direct DURApulse GS4 User Manual page 351

Fault Name
LOCAL
Fault
oL
Overload
LOCAL
Fault
EoL1
Mtr1 Thermal OL
LOCAL
Fault
EoL2
Mtr2 Thermal OL
LOCAL
Fault
oH3
Mtr Overheat-PTC
n/a
LOCAL
Fault
ot1
Over Torque 1
LOCAL
Fault
ot2
Over Torque 2
LOCAL
Fault
uC
Under Current
n/a
LOCAL
Fault
cF1
EEPROM Write Err
DuRA
GS4 AC Drive User Manual – 1st Ed, Rev A - 10/20/2017
pulse
Chapter 6: Maintenance and Troubleshooting
Fault Code
Fault
in Status
Descriptions
Monitor 1
Overload
The GS4 drive
21
detects excessive
drive output
current�
Electronic thermal
22
relay 1 protection
Electronic thermal
23
relay 2 protection
Motor overheating
The GS4 drive
detecting internal
24
temperature
exceeds the setting
of P6�40 (PTC level)
25
reserved
These two fault
codes will be
displayed when
26
output current
exceeds the over-
torque detection
level (P6�15 or
P6�18) and exceeds
over-torque
detection (P6�16 or
27
P6�19) and it is set
to 2 or 4 in P6�14
or P6�17�
Low current
detection
28
(uC does not cause
drive to stop if in
Fire Mode)
29
reserved
Internal EEPROM
30
can not be
programmed�
(continued next page)
Corrective Actions
1) Check if the motor is overloaded.
2) Use the next higher HP drive model.
1) Check the setting of electronics thermal
relay (P6.01)
2) Use the next higher HP drive model.
1) Check the setting of electronics thermal
relay (P6.03)
2) Use the next higher HP drive model.
1) Make sure that the motor is not
obstructed.
2) Ensure that the ambient temperature falls
within the specified temperature range.
3) Use the next higher HP drive model.
n/a
1) Check whether the motor is overloaded.
2) Check whether motor rated current setting
(P0.01) is suitable
3) Use the next higher HP drive model.
Check P6�52, P6�53, P6�54�
n/a
1) Reset to factory settings.
2) Replace the drive. If still under warranty,
please contact AutomationDirect Returns
Department.
Can be
Bypassed
in Fire
Mode
(Yes / no)
no
no
no
Yes
n/a
no
no
no
n/a
no
Page 6–19