Right Side Panel; Use A T20 Torxhead Screwdriver To Remove The Screw At Each Corner Of The Right Side Panel; Shutting Down The Tsq 8000 Evo; Restart Your System By Following The Instructions In - Thermo Scientific TSQ 8000 Evo Hardware Manual

3
Advanced Troubleshooting
Replacing the Covers of the TSQ 8000 Evo Instrument

Right Side Panel

258 TSQ 8000 Evo Hardware Manual
 To replace the right side panel of the TSQ 8000 Evo instrument
Note See the TSQ 8000 Evo Spare Parts Guide for information about ordering this
component.
1. Shut down your system by following the steps in
System" on page 107.
Note You do not have to remove the ion source cartridge. However, you must vent the
instrument and remove the column.
2. Remove the column from the transfer line completely.
3. Slide the top cover panel toward the back of the instrument and lift it off.
4. Use a T20 Torxhead screwdriver to remove the screw at each corner of the right side
panel.
Figure 275. Removing the Right Side Panel Screws
5. Replace the right side panel and tighten the screws.
6. Replace the top cover panel and tighten the screw holding it in place.
7. Reinsert the column to the proper length and tighten the transfer line nut. See
a Column" on page 12

8. Restart your system by following the instructions in

Right Side
Panel Screws
for more information.

"Shutting Down the TSQ 8000 Evo

"Restarting the System"
"Replacing
on page 120.
Thermo Scientific