Air Deflector - Thermo Scientific TSQ 8000 Evo Hardware Manual

3
Advanced Troubleshooting
Replacing Fans and Filters

Air Deflector

364 TSQ 8000 Evo Hardware Manual
 To replace the air deflector
Note See the TSQ 8000 Evo Spare Parts Guide for ordering information.
1. Shut down your system by following the steps in
System" on page 107. You do not need to remove the ion source cartridge or column or
vent the instrument. If you are using hydrogen as a carrier gas, power off the GC.
2. Slide the top cover panel toward the back of the instrument and lift it off.
3. Use a T20 Torxhead screwdriver to remove the four screws securing the left hand front
panel to the chassis. One of the screws is located on the interior front panel of the
instrument.
Figure 389. Locating the Left Hand Front Panel Screws
Left Hand Front
Panel
4. Lift the left hand front panel off the instrument.
5. Remove the two rivets holding the air deflector to the chassis cooling fan.
"Shutting Down the TSQ 8000 Evo
Screws
Screw on Front
of Instrument
Thermo Scientific