Thermo Scientific TSQ 8000 Evo Hardware Manual page 358

3
Advanced Troubleshooting
Replacing the Calibration Gas Components
332 TSQ 8000 Evo Hardware Manual
5. Use a T20 Torxhead screwdriver to loosen the two screws holding the support bracket to
the bottom of the instrument.
Figure 354. Removing the Controller Interface Board Support Bracket
6. Disconnect the Ethernet cable from the PC communication board.
Figure 355. Disconnecting the Ethernet Cable from the PC Communication Board
Ethernet
Cable
Connector
Connectors
Controller
Interface Board
Support Bracket
Controller
Interface
Board
PC Communication
Board
Thermo Scientific