Thermo Scientific TSQ 8000 Evo Hardware Manual page 233

Thermo Scientific
26. Insert the outer ball seal and then the sealing ball into the metal valve body.
Figure 215. Reinserting the Outer Ball Seal and Sealing Ball
Sealing Ball
Outer Ball Seal
O-Ring
Note The sealing ball should slide easily into the interlock. The groove in the ball should
interact with the axle and the small hole on the ball will face away from the vacuum
manifold.
27. Insert the o-ring into the metal valve body.
28. Insert the inner ball seal into the metal valve body.
29. Reattach the small spring and safety interlock to the metal valve body.
Figure 216. Reattaching the Spring and Safety Interlock to the Metal Valve Body
Safety
Interlock
Spring
3
Advanced Troubleshooting
Replacing Components of the Vacuum Interlock
TSQ 8000 Evo Hardware Manual 207