Thermo Scientific
5. The lens driver board is the first board standing on end in the center of the instrument
Figure 384. Locating the Lens Driver Board
6. Look through the left side of the instrument and use a T20 Torxhead screwdriver to
loosen the screw holding the board to the chassis.
Tip The bracket has a white diagram describing the location of this screw. It is
approximately two inches from the top of the board directly under the white label.
3
Advanced Troubleshooting
Replacing Fans and Filters
Lens Driver
Bracket
Board
TSQ 8000 Evo Hardware Manual
359