Upgrading Software On The Computer - Thermo Scientific TSQ 8000 Evo Hardware Manual

Upgrading Software on the Computer

Thermo Scientific
Figure 269. Resetting the System
IMPORTANT These instructions refer to Thermo Foundation 3.0 SP2 and Xcalibur 3.0.
Check the latest Thermo Scientific software CD for the latest versions of Thermo
Foundation and Xcalibur. If the CD contains later versions, follow the steps in the
installation help document on the CD to update your software.
To use Thermo Foundation 3.0 SP2 and Xcalibur 3.0 on Thermo Scientific GC-MS systems,
you must have Xcalibur 3.0 Core Components for GC-MS installed on your computer.
This section describes how to reinstall the Foundation 3.0 SP2 and Xcalibur 3.0 core
components, which are needed to run Foundation 3.0 SP2 and Xcalibur 3.0 on the TSQ
8000 Evo system.
Note There is an electronic version of this installation help document available on the
Xcalibur 3.0Core Components for GC-MS CD. To view this document, select Browse
CD and open the Installation Help.pdf.
Note Before you can load Xcalibur 3.0 Core Components for GC-MS, you must have
administrative privileges on the computer being loaded with the new software.
Reinstalling the TSQ 8000 Evo System Software
Reset Button
3
Advanced Troubleshooting
TSQ 8000 Evo Hardware Manual 249