3
Advanced Troubleshooting
Replacing the Boards in the TSQ 8000 Evo Instrument
284
TSQ 8000 Evo Hardware Manual
6. Look through the left side of the instrument and use a T20 Torxhead screwdriver to
loosen the screw holding the board to the chassis.
Tip The bracket has a white diagram describing the location of this screw. It is
approximately two inches from the top of the board directly under the white label.
Figure 304. Removing the Lens Driver Board
7. Loosening the screw will separate the board from the instrument. The screw is captured,
so do not attempt to completely remove the screw from the board and bracket.
8. Lift the lens driver board out of the instrument. Be careful as space is limited.
Lens Driver Board Screw
Thermo Scientific