Back Manifold Plate - Thermo Scientific TSQ 8000 Evo Hardware Manual

Back Manifold Plate

Thermo Scientific
 To replace the back manifold plate:
Note See the TSQ 8000 Evo Spare Parts Guide for information about ordering this
component.
1. Shut down your system by following the steps in
System" on page 107.
Note You do not have to remove the ion source cartridge.
2. Pull the column fully out of the transfer line and move the instrument away from the GC.
3. Slide the top cover panel toward the back of the instrument and lift it off.
4. Use a T20 Torxhead screwdriver to remove the screw at each corner of the right side
panel.
Figure 248. Removing the Right Side Panel Screws
Replacing Components of the Manifold
"Shutting Down the TSQ 8000 Evo
Right Side
Panel Screws
TSQ 8000 Evo Hardware Manual
3
Advanced Troubleshooting
229