Thermo Scientific TSQ 8000 Evo Hardware Manual page 399

Thermo Scientific
Figure 399. Reinstalling the Lens Driver Board
Connector for
Lens Driver
Board
26. Look through the left side of the instrument and use a T20 Torxhead screwdriver to
tighten the screw holding the lens driver board in place on the chassis.
27. Replace the right side panel and reattach the four screws.
28. Replace the left hand front panel and reattach the four screws.
29. Replace the top cover panel and reattach the top cover panel screw.
30. Reattach the GC.
31. Restart your system by following the instructions in
3
Advanced Troubleshooting
Replacing Fans and Filters
"Restarting the System" on
TSQ 8000 Evo Hardware Manual
page 120.
373