Table of Contents
Advertisement
*3 Block erase time (Shows the total period for which the E-bit in FLMCR is set. It does not
include the erase verification time)
*4 To specify the maximum programming time (t
flowchart, set the maximum value (403) for the maximum programming count (N).
The wait time after P bit setting (z) should be changed as follows according to the
programming counter value.
*5 For the maximum erase time (t
wait time after E bit setting (z) and the maximum erase count (N):
To set the maximum erase time, the values of z and N should be set so as to satisfy the
above formula.
Examples: When z = 5 [ms], N = 240 times
692
Programming counter value of 1 to 4
Programming counter value of 5 to 403 : z = 500 µs
(max)), the following relationship applies between the
E
t
(max) = Wait time after E bit setting (z) x maximum erase count (N)
E
When z = 10 [ms], N = 120 times
(max)) in the 32-byte programming
P
: z = 150 µs
Advertisement
Table of Contents
