Hitachi H8/3062 Hardware Manual page 421

Bit 4
RE Description
Receiving disabled *
0
Receiving enabled *
1
Notes: *1 Clearing the RE bit to 0 does not affect the RDRF, FER, PER, and ORER flags. These
flags retain their previous values.
*2 In the enabled state, serial receiving starts when a start bit is detected in asynchronous
mode, or serial clock input is detected in synchronous mode. Select the receive format
in SMR before setting the RE bit to 1.
Bit 3—Multiprocessor Interrupt Enable (MPIE): Enables or disables multiprocessor interrupts.
The MPIE bit setting is valid only in asynchronous mode, and only if the MP bit is set to 1 in
SMR. The MPIE bit setting is ignored in synchronous mode or when the MP bit is cleared to 0.
Bit 3
MPIE Description
0 Multiprocessor interrupts are disabled (normal receive operation) (Initial value)
[Clearing conditions]
•
•
Multiprocessor interrupts are enabled *
1
Receive-data-full interrupts (RXI), receive-error interrupts (ERI), and setting of
the RDRF, FER, and ORER status flags in SSR are disabled until data with the
multiprocessor bit set to 1 is received.
Note: * The SCI does not transfer receive data from RSR to RDR, does not detect receive errors,
and does not set the RDRF, FER, and ORER flags in SSR. When it receives data in which
MPB = 1, the SCI sets the MPB bit to 1 in SSR, automatically clears the MPIE bit to 0,
enables RXI and ERI interrupts (if the TIE and RIE bits in SCR are set to 1), and allows the
FER and ORER flags to be set.
Bit 2—Transmit-End interrupt Enable (TEIE): Enables or disables the transmit-end interrupt
(TEI) requested if TDR does not contain valid transmit data when the MSB is transmitted.
Bit 2
TEIE Description
Transmit-end interrupt requests (TEI) are disabled *
0
Transmit-end interrupt requests (TEI) are enabled *
1
Note: * TEI interrupt requests can be cleared by reading the value 1 from the TDRE flag in SSR,
then clearing the TDRE flag to 0, thereby also clearing the TEND flag to 0; or by clearing
the TEIE bit to 0.
Bits 1 and 0—Clock Enable 1 and 0 (CKE1, CKE0): The function of these bits differs for the
normal serial communication interface and for the smart card interface. Their function is switched
with the SMIF bit in SCMR.
1
2
The MPIE bit is cleared to 0
MPB = 1 in received data
(Initial value)
(Initial value)
373