Interrupt Setting - Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual

17.9

Interrupt Setting

[Md.65] Interrupt factor detection flag
This area stores the detecting status of an interrupt factor.
Interrupt factor detection flag
Interrupt factor not detected
Interrupt factor detected
■Buffer memory address
For the buffer memory address of this area, refer to the following.
Page 370 Interrupt setting
[Cd.50] Interrupt factor mask
Set the interrupt factor mask.
Interrupt factor mask
Mask (disable interruption)
Clear mask (enable interruption)
■Buffer memory address
For the buffer memory address of this area, refer to the following.
Page 370 Interrupt setting
■Default value
The default value is 0: Mask.
[Cd.51] Interrupt factor reset request
Perform the interrupt factor reset request.
Interrupt factor reset request
No reset request
Reset request
• The interrupt factor is reset by setting 1: Reset request for this area.
• When the interrupt factor reset request acceptance is completed, 0: No reset request is automatically stored. Storing 0
indicates the completion of the interrupt factor reset request.
■Buffer memory address
For the buffer memory address of this area, refer to the following.
Page 370 Interrupt setting
■Default value
The default value is 0: No reset request.
17 DATA USED FOR POSITIONING CONTROL
472
17.9 Interrupt Setting
Stored value
0
1
Setting value
0
1
Setting value
0
1