Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual page 188

Manual pulse generator operation
Manual pulse generator operation performs positioning in accordance with the number of pulses input from the manual pulse
generator, which is to say that it outputs the same number of pulses that were input. This method is used to manually make
fine adjustments for precise positioning and to obtain positioning addresses.
Output pulse
Positioning
module
Pulse input
Manual pulse generator
■Sub functions for the manual control
For details on the sub functions that can be combined with the manual control, refer to the following.
Page 29 Combining Main and Sub Functions
Refer to the following for more information on each sub function.
Page 209 CONTROL SUB FUNCTION
■Manual control using GX Works3
GX Works3 test mode can be used to perform JOG operations and Inching operation as well as enable/disable manual pulse
generator operation.
■Monitoring manual control
The positioning monitor in GX Works3 can be used to monitor manual control operation. Refer to the following for more
information on the positioning monitor.
Page 327 Positioning Monitor
11 MANUAL CONTROL
186
11.1 Overview of the Manual Control
Travel according to the command pulses
M