Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual page 286

Teaching procedure
The following figure shows the procedure for the teaching operation.
■Example 1
The following figure illustrates the process of teaching for [Da.6] Positioning address/movement amount (example with the
axis 1).
Start
Return to the axis 1 machine
zero point position.
Use manual operation to
move to the target position.
Select "Set "[Da.6] Positioning
address/amount of movement"
with the current value" as the
teaching data.
Set the positioning data number
to use for the teaching process.
Confirm that the teaching
process is complete.
Do you want to
NO
stop the teaching
process?
Turn off "[Cd.190] PLC READY
signal".
Back up the module data.
Confirm completion of module
data backup
End
12 CONTROL SUB FUNCTION
284
12.9 Other Functions
This is performed via JOG operation, inching operation,
or manual pulse generator operation.
Set buffer memory address [1548] to "0".
Set buffer memory address [1549] to the positioning data number.
Confirm that buffer memory address [1549] is "0".
YES
Set buffer memory address [1900] to "1".
Confirm that buffer memory address [1900] is "0".