Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual page 77

The following table shows the external I/O signals used for the machine OPR.
: Required
: Use as necessary
: Not required
[Pr.43] OPR method
Near-point dog method
Stopper method 1
Stopper method 2
Stopper method 3
Count method 1
Count method 2
Data setting method
Creep speed
A creep speed is very slow. The stopping accuracy is low when the machine suddenly stops from a fast
speed. To improve the stopping accuracy of the machine, change the speed to a slow speed. Set this speed in
[Pr.47] Creep speed.
Signal required for control
Near-point dog Zero signal
 
 
 
 
 
 
 
Upper/lower limit Deviation counter
switches clear output
 
 
 
 
 
 
 
Torque limit







8 OPR CONTROL
75
8.2 Machine OPR
8