Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual page 285

Data used in teaching
The following control data is used in teaching.
Setting item
[Cd.1] Module data backup
request
[Cd.38] Teaching data selection
[Cd.39] Teaching positioning data
No.
For details on the settings, refer to the following.
Page 453 [Cd.1] Module data backup request
Page 468 [Cd.38] Teaching data selection
Page 468 [Cd.39] Teaching positioning data No.
Setting Setting detail
value
1 Write the data in the buffer memory to a storage
destination specified by the extension parameter
storage setting. (Positioning data and block start data)
• 0: Not requested
• 1: Requested (After the data is written, 0 is
automatically stored.)
→
Set the write destination of Current feed value.
• 0: Written to [Da.6] Positioning address/movement
amount.
• 1: Written to [Da.7] Arc address.
→ Specify the target data No. for teaching.
(Teaching is performed when the set value is 1 to 600.)
When the teaching has been completed, this data is
cleared to 0.
Buffer memory address
Axis 1 Axis 2
1900
1548 1648
1549 1649
12 CONTROL SUB FUNCTION
12.9 Other Functions
12
283