Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual page 472

[Cd.180] Axis stop signal
• When Axis stop signal is turned on, the OPR control, positioning control, JOG operation, inching operation, and manual
pulse generator operation will stop.
• By turning on the axis stop signal during the positioning operation, the operation will be stopped.
• Whether to decelerate or suddenly stop can be selected with [Pr.39] Stop group 3 sudden stop selection.
• During the interpolation control of the positioning operation, if the axis stop signal of any axis is turned on, all axes in the
interpolation control will decelerate and stop.
• The acquisition cycle of the axis stop signal is the same as the calculation cycle.
Axis stop signal
Axis stop request
No axis stop request
■Buffer memory address
The following table shows the buffer memory address of this area.
Buffer memory name
[Cd.180] Axis stop signal
■Default value
The default value is 0 for all the axes.
[Cd.181] Forward JOG Start Signal,[Cd.182] Reverse JOG Start Signal
• When the JOG start signal is on, JOG operation is performed per [Cd.17] JOG speed. When this signal is turned off, the
operation will decelerate and stop.
• When an inching movement amount is set, the specified movement amount is output for 1.77 ms, and then the operation
stops.
• The acquisition cycle of the JOG start signal is the same as the calculation cycle.
Forward JOG start signal, Reverse JOG start signal
JOG started
JOG not started
■Buffer memory address
The following table shows the buffer memory address of this area.
Buffer memory name
[Cd.181] Forward JOG Start Signal
[Cd.182] Reverse JOG Start Signal
■Default value
The default value is 0 for all the axes.
17 DATA USED FOR POSITIONING CONTROL
470
17.8 Control Data
Setting value
1
Other than 1
Axis 1
30100
Setting value
1
Other than 1
Axis 1
30101
30102
Axis 2
30110
Axis 2
30111
30112