Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual page 426

[Da.14] Parameter
Set a value according to the value set in [Da.13] Special start instruction.
Special start instruction
Block start
Condition start
Wait start
Simultaneous start
Repeated start (FOR loop)
Repeated start (FOR condition)
For the setting, refer to the following and check the assignment of this area.
Page 423 [Da.13] Special start instruction
■Buffer memory address
For the buffer memory address of this area, refer to the following.
Page 542 Block start data
■Setting range
The setting range depends on the setting of [Da.13] Special start instruction.
Setting of [Da.2] Control method
Condition start
Wait start
Simultaneous start
Repeated start (FOR condition)
Repeated start (FOR loop)
■Default value
The default value is 0 for all the axes.
17 DATA USED FOR POSITIONING CONTROL
424
17.5 Block Start Data
Description
Not used. (Setting this item is not required.)
Set the condition data No. (number of Condition data which is set to perform condition judgment).
(For more on condition data, refer to Page 425 Condition Data)
Set the number of repetitions.
Set the condition data No. (number of Condition data which is set to perform condition judgment).
(For more on condition data, refer to Page 425 Condition Data)
Setting value
1 to 10
0 to 255 (00H to FFH)
Setting detail
Condition data No.
Number of repetitions