Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual page 381

[Pr.62] Electronic gear selection
Select an electronic gear (16 bits or 32 bits) to use.
Electronic gear selection
16 bit
32 bit
The addresses used by the buffer memory areas shown below depend on the setting of this area.
Setting value of [Pr.62]
Electronic gear selection
0: 16bit
1: 32bit
■Buffer memory address
The following table shows the buffer memory address of this area.
Buffer memory name
[Pr.62] Electronic gear selection
■Default value
The default value is 0: 16 bits for all the axes.
[Pr.2] No. of pulses per rotation (32 bits) (Ap)
Set the number of pulses required for a rotation of the motor shaft with 32 bits. When [Pr.62] Electronic gear selection is set to
1: 32 bits, this area is valid. When the resolution per rotation of the servomotor of the servo amplifier used exceeds 65535
pulses, set the number of pulses per rotation with this area.
■Buffer memory address
The following table shows the buffer memory address of this area.
Buffer memory name
[Pr.2] No. of pulses per rotation (32 bits) (Ap)
■Setting range
The setting range is 1 to 200000000.
■Default value
The default value is 20000 for all the axes.
Address of [Pr.2] No. of pulses per rotation
• Axis 1: 1
• Axis 2: 151
• Axis 1: 102, 103
• Axis 2: 252, 253
Axis 1
100
Axis 1
102
103
Setting value
0
1
Address of [Pr.3] Movement amount per
rotation
• Axis 1: 2
• Axis 2: 152
• Axis 1: 104, 105
• Axis 2: 254, 255
Axis 2
250
Axis 2
252
253
17 DATA USED FOR POSITIONING CONTROL
17
379
17.3 Basic Setting