Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual page 430

[Da.19] Parameter 2
Set the parameters according to the value set in [Da.16] Condition operator.
Setting of [Da.16] Condition
operator
01H: **=P1
02H: **≠P1
03H: **≤P1
04H: **≥P1
05H: P1≤**≤P2
06H: **≤P1, P2≤**
07H: DEV=ON
08H: DEV=OFF
10H: Axis 1 specification
20H: Axis 2 specification
■Buffer memory address
For the buffer memory address of this area, refer to the following.
Page 544 Condition data
■Default value
The default value is 0 for all the axes.
17 DATA USED FOR POSITIONING CONTROL
428
17.6 Condition Data
Setting Description
value

Not used. (Setting this item is not required.)
Numerical Set the value of P2 to be equal to or greater than the value of P1 (P1 ≤ P2).
value If P1 is greater than P2 (P1 > P2), Condition data error (Error code: 1A04H) occurs.
(bit number)

Not used. (Setting this item is not required.)
