Wiring Harness Routing Diagram - Suzuki Intruder VZ1500 Service Manual

9A-5 Wiring Systems:

Wiring Harness Routing Diagram

1. Clamp
: Bind the handlebar switch (L) lead wire and clutch cable with the clamp. Cut the
tip of clamp after clamping.
2. Clamp
: Bind the handlebar switch (R) lead wire and brake hose with the clamp. Cut the
tip of clamp after clamping.
3. Clamp
: Bind the wiring harness with the clamp.
4. Clamp
: Bind the handlebar switch harness (L & R) and wiring harness with the clamp.
5. Clamp
: Bind the handlebar switch harness (L & R) with the clamp.
6. Clamp
7. Clamp
: Bind the GP switch lead wire, side stand switch lead wire and wiring harness
with the clamp.
8. Clamp
9. Clamp
: Bind the rear brake light switch lead wire and starter motor lead wire with the
clamp.
10. Clamp
6
7
" e "
" a "
11
"C"
" b "
" d "
2
" c"
"A"
5
6
8
3
6
8
8
8
10
11. Clamp
: Bind the HO2 sensor lead wire with the clamp.
"A": Pass the handlebar switch (R) lead wire in front of the guide.
"B": Pass the handlebar switch (L) lead wire in front of the guide.
"C": Pass the wiring harness inside of the seat lock cable.
"D": Set the coupler between fuel feed hose and air cleaner tube.
"a": 15 – 25 mm (0.6 – 1.0 in)
"b": 5 – 10 mm (0.2 – 0.4 in)
"c": 130 – 140 mm (5.1 – 5.5 in)
"d": 5 – 15 mm (0.2 – 0.6 in)
"e": 10 – 20 mm (0.4 – 0.8 in)
B940H29102002
1
" b "
"B"
6
4
"D"
9
I940H1910907-08