Suzuki Intruder VZ1500 Service Manual page 431

21) Remove the oil seal (19) and O-ring (20) from the
bearing stopper.
Assembly
Reassemble the final gear case in the reverse order of
disassembly. Pay attention to the following points:
• Install a oil seal (1) and O-ring (2) to the bearing
stopper.
NOTE
The removed oil seal (1) and O-ring (2) must
be replaced with new ones.
• Install the final drive gear bearing into the final gear
case with the special tool.
Special tool
(A): 09913–75821 (Bearing installer)
19
20
I940H1310051-01
1
2
I822H1310066-01
(A)
I822H1310089-02
Drive Chain / Drive Train / Drive Shaft:
• Install the oil seal into the final gear case with the
special tool.
Special tool
(B): 09913–76010 (Bearing installer)
CAUTION
!
• Use a new oil seal to prevent oil leakage.
• The lip and spring of the oil seal "A"
should face to the driven bevel gear side.
• Apply grease to the oil seal lip.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
"A"
• Install the final driven gear bearing into the final gear
case with the special tool.
Special tool
(C): 09951–16080 (Bearing installer)
NOTE
The stamped mark side of bearing face to the
driven bevel gear side.
3A-17
(B)
I822H1310068-03
(C)
I822H1310071-02