Tightening Torque - Suzuki Intruder VZ1500 Service Manual

8) Tighten the new clutch sleeve hub nut (12) to the
specified torque.
CAUTION
!
Do not use the removed clutch sleeve hub
nut.

Tightening torque

Clutch sleeve hub nut (b): 95 N·m (9.5 kgf-m,
68.5 lbf-ft)
(A)
9) Lock the clutch sleeve hub nut with a center punch.
10) Install the spring washer seat (13) and spring washer
(14) onto the clutch sleeve hub correctly.
13
12
(b)
I940H1530029-03
I940H1530014-01
14
I940H1530028-02
11) Insert the clutch drive plates and driven plates one
by one into the clutch sleeve hub in the prescribed
order.
NOTE
Insert the outermost No. 2 drive plate claws
"D" to the other slits "E" of clutch housing as
shown in the figure.
16
15
19
15. No. 3 drive plate
16. No. 1 drive plate
17. No. 2 drive plate
18. No. 2 driven plate (0 – 2 pcs.)
: The No. 1 and No. 2 driven plates are 8 in total.
19. No. 1 drive plate (8 – 6 pcs.)
: The No. 1 and No. 2 driven plates are 8 in total.
"F": Direction of outside
Clutch:
"E"
"D"
I940H1530030-02
17
"F"
19 18/19
I940H1530065-03
5C-10