Suzuki Intruder VZ1500 Service Manual page 494

5B-8 Manual Transmission:
5) Remove the left driveshaft bearing (4) with the
special tool.
Special tool
(D): 09913–70210 (Bearing installer set)
6) Remove the bearing retainers (5).
5
7) Remove the right gearshift cam bearing (6) by hand.
8) Remove the right countershaft bearing (7) and right
driveshaft bearing (8) with the special tool.
Special tool
: 09921–20240 (Bearing remover set)
Installation
Install the each bearing in the reverse order of removal.
Pay attention to the following points:
CAUTION
!
The removed bearing must be replaced with a
new one. (Except for right gearshift cam
bearing)
(D)
4
I940H1520030-01
5
I940H1520031-01
8
7
6
I940H1520032-01
• Install the right driveshaft bearings (1) and
countershaft bearing (2) with the special tool and
install the right gearshift cam bearing (3) by hand.
CAUTION
!
Use the special tool suitable size for each
bearing to prevent damage.
NOTE
• The sealed side "A" of right driveshaft
bearing (1) faces outside of crankcase.
• The stamped mark side of the bearing
faces inside of crankcase.
Special tool
: 09913–70210 (Bearing installer set)
1
• Apply thread lock to the screws, and install the
retainers (4) by tightening them.
: Thread lock cement 99000–32050
(THREAD LOCK CEMENT 1342 or equivalent)
4
"A"
I940H1520033-01
1
2
3
I940H1520034-01
4
I940H1520035-01