Water Pump Disassembly And Assembly - Suzuki Intruder VZ1500 Service Manual

Water Pump Disassembly and Assembly

Refer to "Water Pump Removal and Installation
(Page 1F-11)".
Disassembly
1) Disconnect the water hoses.
2) Remove the connector (1) and water pump case (2).
1
3) Remove the O-ring (2).
4) Remove the E-ring (3), cap (4), pin (5) and washer
(6).
5) Remove the impeller assembly (7).
3
4
B940H21606017
2
I940H1160028-01
2
I940H1160030-01
7
5
6
I940H1160031-02
Engine Cooling System:
6) Remove the mechanical seal ring (8) and rubber
seal (9) from the impeller assembly.
7) Remove the mechanical seal with the special tool.
NOTE
If there is no abnormal condition, the
mechanical seal removal is not necessary.
Special tool
(A): 09921–20240 (Bearing remover set)
8) Remove the oil seal.
NOTE
If there is no abnormal condition, the oil seal
removal is not necessary.
1F-13
9
8
I940H1160032-01
(A)
I940H1160033-01
I940H1160034-01