Suzuki Intruder VZ1500 Service Manual page 364

1K-3 Exhaust System:
9) Remove the front muffler (9) along with the exhaust
pipe.
9
10) Remove the front exhaust pipe (10).
11) Remove the HO2 sensor (11) from the exhaust pipe.
CAUTION
!
• Be careful not to expose it to an excessive
shock.
• Be careful not to twist or damage the
sensor lead wire.
I940H11B0009-01
10
I940H11B0016-01
11
I940H11B0010-02
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Tighten the HO2 sensor to the specified torque.
Tightening torque
HO2 sensor (a): 48 N·m (4.8 kgf-m, 34.5 lbf-ft)
CAUTION
!
• Be careful not to expose it to an excessive
shock.
• Do not use an impact wrench when
installing the HO2 sensor.
• Be careful not to twist or damage the
sensor lead wires.
• Do not apply oil or other materials to the
sensor air hole.
• Install the exhaust pipe gaskets (1) and connector (2).
CAUTION
!
Replace the gaskets and connector with new
ones.
(a)
I940H11B0011-01