Regulator / Rectifier Inspection - Suzuki Intruder VZ1500 Service Manual

1J-8 Charging System:

Regulator / Rectifier Inspection

Inspect the regulator/rectifier in the following procedures:
1) Turn the ignition switch to OFF position.
2) Remove the left frame lower cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-5)".
3) Remove the regulator/rectifier (1).
5) Measure the voltage between the terminals using the multi-circuit tester as indicated in the following table. If the
voltage is not within the specified value, replace the regulator/rectifier with a new one.
NOTE
If the tester reads 1.4 V and below when the tester probes are not connected, replace its battery.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Diode test ( )
Unit: V
(–) probe of tester to:
*1.4 V and more (tester's battery voltage)
6) Connect the regulator/rectifier couplers and bind the clamp.
B940H21A06005
1
I940H11A0017-02
B/W
B/R
B/R
B/R —
B/W *
B *
1
B *
2
B *
3
4) Disconnect the regulator/rectifier couplers (2).
2
B B B
1 2 3
I822H11A0019-01
(+) probe of tester to:
B/W B
1
0.3 – 1.0 0.1 – 0.8
— *
0.1 – 0.8 —
0.1 – 0.8 *
0.1 – 0.8 *
I940H11A0018-02
B B
2 3
0.1 – 0.8 0.1 – 0.8
* *
* *
— *
* —