Cushion Lever Bearing Removal And Installation - Suzuki Intruder VZ1500 Service Manual

Cushion lever bearing
1) Insert the spacers into bearings.
2) Check the play by moving the spacers up and down.
If excessive play is noted, replace the bearing with a
new one. Refer to "Cushion Lever Bearing Removal
and Installation (Page 2C-8)".
Cushion lever
Inspect the cushion lever for damage. If any defect is
found, replace the cushion lever with a new one.
Cushion Lever Bearing Removal and
Installation
Refer to "Swingarm Assembly Removal and Installation
(Page 2C-3)".
Removal
1) Remove the cushion lever seal (1).
1
2) Remove the cushion lever bearings using the special
tools.
Special tool
I940H1230021-01
I940H1230022-01
B940H22306011
I940H1230023-01
Rear Suspension:
(A): 09921–20240 (Bearing remover set)
(B): 09913–70210 (Bearing installer set)
(B)
2C-8
(A)
I940H1230024-01
I940H1230025-01